搜索结果: 1-9 共查到“机械工程 Alloys”相关记录9条 . 查询时间(0.015 秒)
New Inclusion Assessment Method in Aluminum Alloys —Electrochemical Method for Inclusion Assessment (EcMIA)
aluminum alloys inclusion assessment electrochemical parameters
2011/8/4
The existence of inclusion influences the properties of aluminum alloy castings, from which the castings will face scrapping under severe condition. Great efforts on the inclusions in aluminum alloy w...
Crystallographic Characteristic of Intermetallic Compounds in Al-Si-Mg Casting Alloys by Using Electron Backscatter Diffraction
Al-Si-Mg alloys intermetallic compound electron backscatter diffraction (EBSD)
2011/8/3
The Al-Si-Mg alloy which can be strengthened by heat treatment is widely applied to the key components of aerospace and aeronautics. Iron-rich intermetallic compounds are well known to be strongly inf...
Investigations on the suitability of some ferrous alloys for semi-solid processing
Casting Thixoability Thixoforming
2009/12/14
Purpose: the work analyses the thixoability of SAE 1070, SAE 1548 and SAE 4340 steels; the possibility of producing thixotropic semi-solid by partial melting of these alloys and the phase transformati...
Microstructure and properties of FSW joints of 2017A/6013 aluminium alloys sheets
Friction Stir Welding Aluminium alloy 2017A Aluminium alloy 6013
2009/12/2
Purpose: The aim of the studies was to analyse the structure and mechanical properties of FSW joints. Experiment were perform in order to study possibilities to join different aluminium alloys 2017A a...
Wear Behaviour of Zinc-Aluminium Alloys and the Bearings Produced from these Alloys
Zinc-aluminum alloys journal bearings wear
2009/10/14
In this study, two ternary zinc-aluminum-copper and two quaternary zinc-aluminum-copper-silicon alloys were produced by permanent mould casting. The wear behaviour of these alloys were investigated wi...
Laser Beam Welding of AA5052, AA5083, and AA6061 Aluminum Alloys
Laser Beam Welding AA5052 AA5083 AA6061 Aluminum Alloys
2009/9/2
The present investigation was mainly concerned with characteristics of autogeneous laser butt welding of 2 mm thickness nonheat treatable AA5052-H12, AA5083-H12 and 2 mm, 3 mm thickn...
Optimization of Surface Roughness in End Milling on Mould Aluminium Alloys (AA6061-T6) Using Response Surface Method and Radian Basis Function Network
Response Surface Method Radian Basis Function Network Surface roughness
2010/1/15
This paper is concerned with optimization of the surface roughness when milling Mould Aluminium alloys (AA6061-T6) with carbide coated inserts. Optimization of milling is very useful to reduce cost an...
Anodization of cast aluminium alloys produced by different casting methods
Aluminium cast alloys Mechanical properties Surface treatment Alumina layer Anodizat
2011/3/17
In this paper the usability of two casting methods, of sand and high pressure cast for the anodization of AlSi12 and AlSi9Cu3 aluminium cast alloys was investigated. With defined anodization parameter...
Abrasive wear of high chromium Fe-Cr-C hardfacing alloys
hardfacing alloy abrasive wear Pin-on-disk carbide
2014/2/27
Weld deposits are one of the most used economical ways of the wear resistance increase. The study compares the characteristics of the overlay material welded-on and the abrasive wear resistance. The r...