搜索结果: 1-7 共查到“林业工程 Chip”相关记录7条 . 查询时间(0.093 秒)
The use of bioenergy for district heating is usually seasonal with a high consumption during the cold periods. Therefore some type of the harvested material storage is necessary. Woody materials are u...
Cutting Performance and Wear Characteristics of Chromium Nitride Coated Tools II.The chip forming ability of worn tools in edge-grain milling of spruce
CrN coated tool chip formation tool wear up-milling
2010/3/4
To establish the cutting performance and tool wear characteristics of a cemented carbide tool with clearance faces coated with CrN (UP), edge grain surfaces of spruce were milled with a 134 mm diamete...
Binder-less Wood Chip Insulation Panel for Building Use Made from Wood Processing Residues and Wastes IV
insulation panel wood shavings thermal conductivity thermal diffusivity heat storage capacity
2009/3/6
This paper describes thermal properties of binder-less wood chip insulation panels, focusing especially on the effect of panel thickness and on comparisons with the glass wool and phenolic foam panel...
Chip Orientation Measurement Using a Profile Measuring Sensor for Recycled Chips from Waste Timber
recycled chip chip orientation image analysis surface profile fast Fourier transform
2009/3/6
Surface data of three differently oriented forming mats were obtained by profile measuring sensor and by digital camera. Surface profile data were obtained by a profile measuring sensor whereas digita...
Binder-less Wood Chip Insulation Panel for Building Use Made from Wood Processing Residues and Wastes V.
insulation panel sugi bark thermal conductivity drop impact
2009/3/6
In this series of studies, a manufacturing technology was developed which uses wood flakes or shavings for binder-less insulation panels used in buildings. This paper describes the use of sugi (Crypt...
Current state and development possibilities of wood chip supply chains in Austria
wood chip supply chipping energy wood transport bundling technology
2009/2/7
The importance of forest wood chips as fuel for energy production will increase relative to sawmill by-products. The additional production is not a question of potential (harvesting residues, wood f...
Optimization of Veneer Cutting of Sugi I.Fundamental investigation of minimum chip thickness
veneer cutting cutting force burnishing force sugi chip thickness
2010/3/4
Using a test tool with sharp cutting edge, tool angle 30° and clearance angle 0°, the effect of the undeformed chip thickness on the cutting performance in modeled veneer cutting of sugi was investiga...